Chevy Camaro Oil Pressure Switch Location

Its been rebuilt.

Chevy camaro oil pressure switch location. 2010 Chevrolet Camaro 2LT. Now my EOP sensor repair is a 10 minute job not 2 days. It had started to drip on my exhaust and stink like burning oil duh.

Drop it off at our shop and pick it up a few hours later or save time and have our Delivery mechanics come to you. 2010 Camaro Oil Pressure Sensor User Name. It will only cause inaccurate oil pressure readings and possible leaking of oil at the switch.

Faulty oil pressure switch will not cause issues with ignition. But since my dead oil pressure sensor OPS starting leaking it was time to get this DIY out of the way. The oil pressure switch on a 1989 Chevy Camaro RS is located on the bottom of the engine hear the oil filter.

If you are having low oil pressure then the following causes could be present. Good luck and remember rated this help. Might look a little different than a truck motor but the location of the port is the same.

Has anyone else had this issue with a LS3. On the 350 theres a spot on the back of the intake right beside the distriburtor that i use for my oil press. Now she sits at FSP for a new cam and oil pump.

Location for OIL PRESSURE SENSORS are on Engine BLOCK At 90 degree angle BEHIND OIL FILTER And One Just Above the Starter Poking out Same Direction as OIL FILTER I would Suggest that you Replace Both at the same time this IS NOT MANDATORY But I have found it to be a time-saver and Sometimes it IS Necessary to replace them Both. It is much easier to access this piece if you simply remove the distributor cap. Youll have to take the distributor out to get to it.